OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E44

Hybrid/EV Electronics Coolant Pump B Control Circuit High

P2E44 is the opposite fault: the command line of electronics coolant pump B reads higher than its commanded state allows, mostly because it touches a battery-fed wire or the driver can no longer pull it down. Many PWM pumps react to a permanently high input with an emergency mode; Pierburg's interface runs the pump at about 95 % speed for a duty cycle of 98 to 100 %. The loop may therefore stay cooled while the controller has lost all influence on the speed, which also wastes energy and adds noise. Ford's 2024 summary lists circuit high (fault type 12) as a separate failure type of its auxiliary pumps. No manufacturer publicly documents P2E44. Look for harness sections rubbing against live wires, moisture and a defective output stage in the module. P2E43 covers the low side, P0CEC is pump A's equivalent.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 44

Possible causes

  • Control wire shorted to a battery-voltage circuit high
  • Module output stage unable to pull the line low medium
  • Moisture linking supply and signal pins in the connector medium

Symptoms

  • MIL with hybrid system message
  • Pump B runs continuously at high speed, audible hum
  • Pump does not respond to commanded speed changes

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2E44

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication