OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E43

Hybrid/EV Electronics Coolant Pump B Control Circuit Low

P2E43 means the command signal of electronics coolant pump B sits too low, typically because the line has contact with ground or the output stage cannot drive it up. On PWM-controlled pumps this usually stops the pump outright. Pierburg's CWA pumps, a widespread design, read a duty cycle of 0 to 1 % as stop and pull their PWM input to ground through 10 kΩ, so a grounded line leaves the rotor standing. Ford's 2024 summary treats circuit low (fault type 11) on its auxiliary pumps as a report from the smart driver, checked over 5 s at a battery voltage of at least 11 V. GM's 2016 hybrid tables fold grounded, voltage-shorted and open lines into a single pump A code, P0CE9. No manufacturer publicly documents P2E43. Chafed insulation and wet connectors are usual finds. The high-side code is P2E44, pump A's version P0CEB.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 43

Possible causes

  • Control wire chafed through and shorted to ground high
  • Moisture or corrosion bridging pins in the pump connector medium
  • Shorted input stage inside pump B medium
  • Output stage of the module stuck low low

Symptoms

  • Pump B stops, electronics coolant heats up
  • MIL with hybrid or drive system message
  • Limited power or charging rate under load

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2E43

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication