P2E40
Battery Charger B Module Forced Shutdown Voltage High
P2E40 means the forced shutdown signal of charger B reads above its valid band, typically from a short to a 12 V wire or a leak inside the charger or the module that drives it. No manufacturer documents P2E40 publicly. With fail-safe logic, as Watt & Well specifies for the EVCC, where flowing current stands for normal operation, a line held high can no longer pass on a stop order, so the hardware path that should end charging in an emergency is lost. For that reason a control unit would rather keep charger B disabled than run it without a working off-switch. CARB's onboard charger requirement covers this too. Low is P2E3F, implausible P2E3E, charger A high P2E34. The driver mainly notices slower or no charging.
Possible causes
- Shutdown line of charger B shorted to a 12 V wire high
- Internal leakage in charger B or the commanding module medium
- Miswiring after a harness or charger repair low
Symptoms
- Charging slower or impossible with charger B locked out
- Charging system warning message
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2E40
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.