P2E3F
Battery Charger B Module Forced Shutdown Voltage Low
P2E3F reports a forced shutdown signal at charger B that stays below its permitted voltage. No manufacturer documents P2E3F or the shutdown logic behind it publicly. If the line is fail-safe, as at the EVCC controller from Watt & Well, where zero loop current or an unconnected input triggers the stop, then a ground short or a break looks like a standing shutdown command and charger B stays switched off for good. The code lets the system tell that wiring fault from a deliberate request. Likely findings are a damaged wire near the charger mount, a corroded or loose pin in the signal plug, or a commanding output stage stuck low. A charger that cannot run is exactly what CARB wants a plug-in hybrid to report. High is P2E40, implausible P2E3E, charger A low P2E33.
Possible causes
- Shutdown line of charger B shorted to ground high
- Broken wire or loose pin in the signal plug medium
- Output stage of the commanding module stuck low low
Symptoms
- Charger B never takes part in charging
- Reduced charging power or no charging
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2E3F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.