P2E36
Battery Charger B Enable Circuit Low
P2E36 means the enable signal to charger B is pulled under the level its commanded state allows, most often by a short to ground or by a driver stage that cannot pull the line up. No manufacturer documents P2E36 publicly. On the common active-high layout, which Holley's 30-8405 charger unit uses with a 12 V wake-up input drawing about 20 mA, a grounded line simply means the charger never receives its wake request. Lear's patent on waking an on-board charger from the pilot signal explains the background: the charger sleeps to spare the 12 V battery and needs a valid wake signal to start. A hard short may also overload the output stage in the commanding module. GM documents only the general A-side code P0E61. High is P2E37, open P2E35, charger A low P0E62. Charging via charger B fails.
Possible causes
- Enable wire chafed and shorted to ground high
- Water or corrosion in the charger B signal connector medium
- Damaged high-side driver in the commanding module low
Symptoms
- Charger B stays off whenever charging is requested
- Lower charging power or no charging
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2E36
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.