OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E35

Battery Charger B Enable Circuit/Open

P2E35 covers the enable line of charger B, the hardwired 12 V signal that wakes the charger or allows it to work, and reports a general circuit fault, usually an open. No manufacturer documents P2E35 publicly. The A-side code P0E61 is documented by GM: the 2016 Volt (VICM) and the 2019 hybrid tables (HPC2) evaluate a fault flag from the line driver at 10.2 V system voltage or more, 30 bad samples out of 40 at 25 ms, Type B. Holley's 30-8405 charger unit shows why the line counts: the charger only runs with 12 V on its wake-up pin, and without it even its CAN stays silent. Specific level faults are P2E36 and P2E37, plausibility P2E38. With an open line charger B stays asleep; a car with a second charger may still charge slowly through the first.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 35

Possible causes

  • Broken enable wire or backed-out terminal high
  • Signal connector at charger B not fully latched medium
  • Failed enable driver in the commanding module low

Symptoms

  • Charger B does not wake when the cable is plugged in
  • Charging slower than usual or not at all
  • Charging system warning message

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2E35

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication