OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E33

Battery Charger A Module Forced Shutdown Voltage Low

P2E33 reports that the voltage on the forced shutdown line of charger A sits below its valid band. What that means in practice depends on the logic, which no manufacturer publishes for this code. Shutdown lines are often built fail-safe, as in Watt & Well's EVCC charging controller, where a missing loop current counts as an emergency stop. With such logic a wire broken or shorted to ground looks like a permanent shutdown order, so charger A stays off even though nobody asked for it; the code then separates a wiring fault from a genuine request. Typical findings are a chafed wire touching the body, water in a connector or a pulled-out pin. Charger faults that stop charging fall under CARB's plug-in hybrid rule. High is P2E34, implausible behaviour P2E32, charger B low P2E3F.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 33

Possible causes

  • Shutdown line chafed through and shorted to ground high
  • Broken wire or backed-out pin in the shutdown circuit medium
  • Moisture or corrosion in the charger signal connector medium
  • Output stage of the commanding module stuck low low

Symptoms

  • Charger A never starts charging
  • Charging aborts when the car or harness is moved
  • Charging system warning message

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2E33

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication