P2E31
Battery Charger B Module Supply Voltage High
P2E31 is the high-side counterpart of P2E30: the low-voltage feed of charger B climbs above what its control electronics accept. On plug-in cars the DC/DC converter holds the 12 V network, so a converter regulating too high is the main suspect; a workshop charger or jump pack set too high, or a faulty measurement inside charger B, can give the same reading. No manufacturer documents P2E31 or a threshold publicly. Mitsubishi's Outlander PHEV pages put the upper edge of the charger test window at 16 V, for P0D67 as well as for the ROM check P0E5E, and Holley's 30-8405 charger unit is rated up to 16 V. Charger faults that get in the way of charging are covered by CARB. System overvoltage is P0563, the A-side twin P2E2E. Charger B likely stops to protect itself.
Possible causes
- DC/DC converter regulating the 12 V network too high high
- Workshop charger or jump starter with excessive voltage medium
- Faulty supply voltage measurement inside charger B low
Symptoms
- Charging via charger B stops or will not start
- Overvoltage codes stored in several modules
- 12 V battery gassing or lamps unusually bright
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2E31
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.