P2E21
Drive Motor A Phase Y Current Sensor Circuit Low
P2E21 records that the phase Y current sensor of drive motor A reports a value under the bottom of its scale. No manufacturer documents P2E21 publicly. GM's eAssist logic shows a clean way to test for this: the low and high checks of its U and W sensors run while PWM output is disabled, so the inverter is not switching and no phase current can flow. A reading below -440 A in 4 of 6 samples, one every 10.4 ms, then sets the U-phase code as two-trip Type B. Anything that far out at rest can only come from the measuring chain, for example a grounded signal line or a dead sensor supply. Too little real current in phase Y is a different fault, P2C6D. In a Mitsubishi Electric design, X, Y and Z form the second star-connected set. High side: P2E22; X and Z low: P2E1D, P2E25.
Possible causes
- Phase Y sensor signal shorted to ground high
- Sensor supply voltage missing medium
- Phase Y current sensor failed medium
Symptoms
- Hybrid warning lamp and MIL
- Electric drive limited
- Engine runs more often than usual on hybrids
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2E21
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.