P2E1A
Drive Motor A Inverter Voltage Sensor A/B Correlation
P2E1A sets when the two DC voltage readings inside the drive motor A inverter, sensor A and sensor B, stop agreeing although they should describe the same high-voltage potential. Each value may pass its own range test; the fault lies in the mismatch. No manufacturer documents P2E1A publicly. Mitsubishi shows such a cross-check on the 2023 Outlander PHEV, where sensor A reads capacitor 1 and sensor B the main channel of capacitor 2: a gap of at least 50 V lasting 0.2 s is booked under the single-sensor codes P0D2E or P0E8D. Ford's 2019 hybrids file a gap above 60 V between the inverter input and output sensors under P0DA8. Two channels alone cannot show which one is wrong, so Mitsubishi adds the rear motor voltage as a third reference. Expect a warning and limited electric drive.
Possible causes
- One of the two voltage measuring channels in the inverter has drifted high
- Fault in the inverter or power drive unit electronics medium
- Poor high-voltage connection between the two measuring points low
- Control software with an unsuitable comparison window low
Symptoms
- Hybrid system or drive warning lamp, MIL possible
- Reduced or no electric drive power
- Further inverter voltage codes stored at the same time
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2E1A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.