P2E19
Intermediate Shaft Selection Actuator Position Sensor Circuit Intermittent/Erratic
P2E19 is stored when the intermediate shaft selection actuator's position sensor delivers a signal that flickers, drops out briefly or changes faster than the mechanism could physically move. Because the fault comes and goes, the code often shows as pending or with only a few occurrences. No manufacturer documents P2E19 publicly. As an example of what counts as erratic for a digital rod sensor, GM's dual-clutch tables (2023) name a carrier frequency outside 1500 to 2500 Hz for 150 ms (P2835). In Ford's DPS6 an out-of-order Hall pattern from a shift drum motor sets P2835 as well. Wiggle-testing the harness at the gearbox while watching live data is the usual way to find the spot. Steady electrical faults of the same sensor are P2E17 and P2E18.
Possible causes
- Loose or corroded terminal at the actuator or gearbox connector high
- Harness rubbing on the housing, contact only under vibration medium
- Electrical noise from damaged shielding low
- Sensor with an internal intermittent fault low
Symptoms
- Sporadic shift faults that disappear again
- Warning lamp only now and then
- Short limp-mode episodes
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2E19
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.