OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E18

Intermediate Shaft Selection Actuator Position Sensor Circuit High

Here the position sensor of the intermediate shaft selection actuator reports a value above its upper limit. Most often the signal line has contact with battery voltage or the 5 V feed, or the sensor has lost its ground so the output floats upward. No manufacturer documents P2E18 publicly. For a rod sensor, GM's transmission tables from 2023 (23OBDG07) use this rule under P2834: no pulses with more than 3500 mV on the pin, or a duty cycle above 92 %, checked for 150 ms while battery voltage lies between 8.75 and 18 V, Type A. CARB treats such sensors as comprehensive components with mandatory range checks. A voltage check of signal and ground with the actuator plugged in narrows it down quickly. The low fault of the same sensor is P2E17, the high fault of the main selection actuator P2E13.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 18

Possible causes

  • Signal line shorted to battery voltage or the 5 V feed high
  • Sensor ground open or corroded medium
  • Position sensor output stuck high medium
  • Faulty input stage in the transmission control module low

Symptoms

  • MIL and transmission warning
  • Certain gears blocked, limp mode
  • Poor acceleration because the gearbox holds an unsuitable gear

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2E18

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication