OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E17

Intermediate Shaft Selection Actuator Position Sensor Circuit Low

P2E17 tells you the position signal of the intermediate shaft selection actuator is stuck at the bottom of its range or below it. On the bench this usually turns out to be a signal line touching ground, a dead reference supply, or a sensor whose output stage has failed. No manufacturer documents P2E17 publicly. As a reference point, GM's 2023 dual-clutch TCM tables call a rod position sensor low (P2833) when pulses are missing with less than 2000 mV at the pin or when the duty cycle drops below 8 %, Type A. CARB requires transmission inputs to be checked for values outside their range. Start with the connector at the gearbox, then the reference voltage, then the sensor. The matching high fault is P2E18; for the main gear selection actuator the low fault is P2E12.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 17

Possible causes

  • Signal line shorted to ground high
  • Sensor reference voltage missing medium
  • Output stage of the position sensor failed medium
  • Signal wire interrupted (on sensors that then read low) low

Symptoms

  • MIL and transmission warning
  • Limp mode with limited gears
  • Code returns at once after clearing

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2E17

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication