OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E16

Intermediate Shaft Selection Actuator Position Sensor Range/Performance

P2E16 flags a position reading from the intermediate shaft selection actuator that is electrically valid but not credible, for example a travel that does not match the commanded movement or the learned end stops. No manufacturer documents P2E16 publicly. Why learned references matter is explained in Ford's DPS6 dual-clutch summary from 2012: its clutch actuators sense motor position with Hall elements that only count steps, so the system must sweep from one end stop to the other to know the absolute position. If counts are lost or the mechanism no longer reaches its stops, the computed position drifts away from reality. GM judges plausibility of a rod sensor against shaft speeds (P2832 in 23OBDG07). A relearn after battery work or repair may clear the fault; otherwise check the mechanism.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 16

Possible causes

  • End stops not learned or lost after battery disconnect or repair high
  • Actuator or selection linkage binding, target position not reached medium
  • Sensor or its magnet shifted, reading offset medium
  • Control software needs an update low

Symptoms

  • Harsh, slow or failed shifts involving the intermediate shaft
  • Transmission warning, possibly limp mode
  • Fault returns until a relearn has been done

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2E16

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication