P2E15
Intermediate Shaft Selection Actuator Position Sensor Circuit
P2E15 is the basic circuit code for the position sensor of a second selection actuator, one assigned to the intermediate shaft (layshaft) of the gearbox rather than to the main gear selection, which has P2E10 to P2E14. Which gearboxes use such an actuator, and what exactly it engages there, no manufacturer documents publicly for this code. Schaeffler's LuK paper on electric dual-clutch actuators shows the general idea: separate electric motors handle the shift and the select movement, while the select motor moves the shift finger axially into the gate that is needed. The control module needs the position feedback to know whether the selection has been made. CARB requires circuit checks on such transmission sensors. If the signal fails electrically, gear changes that involve this shaft are blocked. P2E16 to P2E19 are the specific variants.
Possible causes
- Connector or harness to the intermediate shaft actuator damaged or corroded high
- Position sensor of the actuator failed medium
- Sensor supply or ground missing medium
- Faulty input stage in the transmission control module low
Symptoms
- Transmission warning and MIL
- Some gears unavailable or gearbox in limp mode
- Vehicle may only drive in a restricted range of gears
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2E15
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.