P2E14
Gear Selection Actuator Position Sensor Circuit Intermittent/Erratic
P2E14 covers a position signal from the gear selection actuator that is present but unsteady: it drops out for moments, jumps or carries an implausible frequency or pattern, without staying low or high long enough for P2E12 or P2E13. No manufacturer documents P2E14 publicly. Two related checks show what erratic means in practice. GM's 2023 dual-clutch TCM tables reject a rod position sensor whose carrier frequency leaves the 1500 to 2500 Hz band for 150 ms (P2835, Type A). Ford's 2012 DPS6 summary watches the three Hall signals of each shift drum motor and sets P2835 if their sequence comes out of order. Loose pins, harness chafing that only touches under vibration, and electrical noise are typical. Drivers notice sporadic refused shifts or brief neutral drops that later vanish.
Possible causes
- Loose or fretted terminal in the actuator connector high
- Harness chafing that only shorts or opens under vibration or heat medium
- Interference from damaged shielding or nearby motor wiring low
- Sensor with an internal intermittent fault low
Symptoms
- Occasional refused or delayed shifts
- Short drops to neutral while driving
- Warning lamp that comes and goes
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2E14
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.