OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E13

Gear Selection Actuator Position Sensor Circuit High

P2E13 is the opposite case to P2E12: the position signal of the gear selection actuator sits above its highest plausible value. A short between the signal line and a supply wire is the classic cause; an open ground or, on pull-up inputs, a broken signal wire produce the same picture. No manufacturer documents P2E13 publicly. GM's 2023 TCM tables for a dual-clutch gearbox treat the high fault of a rod position sensor (P2834) as missing pulses with the pin above 3500 mV, or a duty cycle above 92 %, judged for 150 ms and only with valid sensor supply and battery voltage, Type A. CARB requires such out-of-range tests on transmission sensors. Measuring the line with the sensor unplugged separates a harness short from a sensor defect. The gearbox then normally stops shifting or keeps a fixed gear.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 13

Possible causes

  • Signal wire shorted to a supply or 5 V reference line high
  • Sensor ground open or high resistance medium
  • Position sensor faulty, output stuck high medium
  • Moisture in the actuator connector bridging pins low

Symptoms

  • MIL and transmission warning
  • Gearbox stays in one gear or in neutral
  • Shift lever input ignored

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2E13

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication