OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E12

Gear Selection Actuator Position Sensor Circuit Low

P2E12 sets when the signal of the gear selection actuator's position sensor stays below the lowest valid level. Usual reasons are a short to ground on the signal line, a missing 5 V reference or a defect inside the sensor; with many designs an interrupted signal wire also reads low. No manufacturer documents P2E12 publicly. For a comparable digital rod position sensor, GM's 2023 dual-clutch TCM tables (P2833) give concrete limits: no pulses while the pin sits below 2000 mV, or a duty cycle under 8 %, confirmed after 150 ms with a supply between 4.5 and 5.5 V, Type A. CARB calls for out-of-range checks on such transmission inputs. If several sensors share the reference, other codes often appear at once. The high counterpart is P2E13; the gearbox usually falls back to a safe gear.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 12

Possible causes

  • Signal wire chafed through and shorted to ground high
  • 5 V reference missing or pulled down by another sensor on the same supply medium
  • Signal wire or terminal interrupted medium
  • Internal short in the position sensor low

Symptoms

  • MIL and transmission warning immediately
  • Limp mode, no gear changes or only one gear
  • Further sensor codes if the shared 5 V supply is affected

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2E12

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication