OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E11

Gear Selection Actuator Position Sensor Performance

With P2E11 the position sensor of the gear selection actuator delivers values that are electrically fine but do not fit the situation: the reading stays put although the actuator was driven, or it contradicts the gear that shaft speeds prove to be engaged. No manufacturer documents P2E11 publicly. In GM's TCM tables of 2023 for a dual-clutch box (23OBDG07) one can see how such a plausibility test works on a shift rod sensor under P2832: when speed sensors confirm an engaged gear with more than 600 N of shift force applied, yet the reading lies over 1100 µm from the learned engaged position, a Type A fault follows. Ford's DPS6 flags a comparable loss of confidence in the shift drum position, including a blocked motor, under the same P2832. Typical causes are a shifted sensor magnet, mechanical wear or lost learned values.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 11

Possible causes

  • Learned end positions lost or outdated, e.g. after battery disconnect or part replacement high
  • Sensor magnet or sensor mounting shifted, reading offset medium
  • Wear or binding in the selection mechanism, actuator does not reach its target medium
  • Sensor characteristic drifted low

Symptoms

  • Delayed or harsh shifts, gear sometimes not engaged
  • Transmission warning, possibly limp mode with fixed gear
  • Fault may clear after a relearn procedure

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2E11

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication