P2E10
Gear Selection Actuator Position Sensor Circuit
P2E10 is the general circuit code for the sensor reporting where the gear selection actuator stands, the motor-driven unit that moves the shift mechanism of an automated manual or dual-clutch gearbox to the wanted gear or gate. The control module stores it when signal or supply of that sensor are electrically faulty in a way the dedicated low, high or erratic codes do not cover. No manufacturer documents P2E10 publicly. Ford's 2012 summary for the DPS6 dual-clutch box illustrates the principle: Hall elements in each shift drum motor tell the TCM where the drum stands, and from that the engaged gear. CARB counts such transmission sensors among the comprehensive components that need circuit checks. Without a usable position the gearbox usually refuses shifts or holds one gear. P2E11 to P2E14 are the specific siblings.
Possible causes
- Corroded or loose connector, damaged harness at the actuator high
- Position sensor in the actuator failed (often only replaceable with the actuator) medium
- Sensor reference voltage missing or loaded down by another fault medium
- Input stage in the transmission control module faulty low
Symptoms
- Transmission warning and MIL
- Gearbox holds one gear or goes to neutral (limp mode)
- Shifts refused or engaging drive or reverse not possible
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2E10
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.