P2E0E
Gear Lever Position Sensor D Circuit Low
P2E0E is set when the output of gear lever position sensor D drops beneath its lowest plausible level, usually near 0 V or 0 % duty cycle. Likely reasons are a ground short in the D signal path, a sensor without feed or a Hall element whose output died. No maker publishes P2E0E or a meaning for sensor D. Toyota's patent US10180184 treats such hard electrical faults as continuously detectable and keeps the shift position available from the three other sensors; a second abnormality then calls for a fail-safe such as neutral. For comparison, GM flags low per axis on its two-sensor XT4 lever below 5 % duty cycle (P082E, P08A1). Out-of-range detection is a CARB 1968.2 (e)(15) duty. Sensor D high is P2E0F, sensor C low P2E0A.
Possible causes
- Signal path of sensor D shorted to ground high
- Sensor D without supply medium
- Hall element of sensor D failed low medium
Symptoms
- Shift-system warning
- Selector still usable on the other sensors
- Shift to neutral if another sensor fails
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2E0E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.