P2E0D
Gear Lever Position Sensor D Range/Performance
With P2E0D the fourth lever sensor, D, stays within its electrical limits but its reading does not fit the lever position. No manufacturer documents P2E0D. Toyota's four-sensor patent (US10180184) gives a model for such a test: the module compares the voltage differences between the Hall sensors with a preset tolerance and declares one abnormal if it falls outside. A second check in the patent matters while driving: the remaining sensors must not report a range for the opposite direction of travel, which guards against a wrong forward/reverse change. A sensor stuck at a middle value may pass until a specific lever position is selected, so the code can appear late. CARB 1968.2 (e)(15) requires rationality checks of transmission inputs. Sensor C's equivalent is P2E09.
Possible causes
- Sensor D frozen at a middle value high
- Magnet position in the lever changed by wear or impact medium
- Selector software tolerance needs an update low
Symptoms
- Code appears only after selecting a certain position
- Warning lamp or shift message
- Limp-home with fewer sensors
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2E0D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.