P2E0B
Gear Lever Position Sensor C Circuit High
P2E0B: sensor C of the gear lever reports more than its maximum valid signal. That is the typical picture of a broken signal wire on a pulled-up input, contact with the feed line or a lost sensor ground. No manufacturer documents P2E0B, and the function of a third lever sensor is nowhere specified publicly. Toyota's patent US10180184 shows why a selector might carry one: with four Hall sensors one can drop out while three still define the lever position; only if another abnormality follows does the patent foresee a fail-safe such as a shift to neutral. On GM's two-sensor lever, duty cycles above 95 % raise the per-axis codes P082C and P089D. Low is P2E0A. CARB 1968.2 (e)(15) requires two-sided range checks on such inputs.
Possible causes
- Signal wire of sensor C open high
- Ground of sensor C interrupted medium
- Signal wire shorted to supply voltage low
Symptoms
- Warning lamp or shift message
- Selector keeps working with the other sensors
- Neutral forced if another sensor also fails
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2E0B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.