P2E0A
Gear Lever Position Sensor C Circuit Low
For P2E0A the module reads the signal of gear lever sensor C below the window a working sensor can occupy. On a voltage-output Hall sensor like those in Toyota's four-sensor selector patent (US10180184), this means a signal line pulled to ground, a missing feed or a sensor that has stopped driving its output. The same patent counts disconnection and short circuits as faults that can be detected continuously, and lets the remaining three sensors run a limp-home mode. No manufacturer documents P2E0A or tells what sensor C measures. CARB 1968.2 (e)(15) demands detection of out-of-range input values. The high side is P2E0B; GM's comparable per-axis low checks on its two-sensor lever are P082B and P089C, with a 5 % duty-cycle limit.
Possible causes
- Signal wire of sensor C shorted to ground high
- Supply of sensor C missing medium
- Sensor C output failed low medium
Symptoms
- Warning lamp or shift message
- Limp-home on the remaining sensors
- No noticeable change while other sensors are valid
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2E0A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.