P2E06
Gear Lever Position Sensor B Circuit Low
The signal of sensor B, the redundant gear lever sensor, has dropped under its permitted minimum. Electrically that points to a short to ground in its signal line, a dead sensor or a missing feed on its own supply branch. P2E06 is not published by any manufacturer. GM catches the same condition per axis on the XT4 selector as P089C (X) and P08A1 (Y), each when the PWM duty cycle of sensor 2 stays below 5 % for three failures in four samples; Type B with a two-trip MIL. Because sensor A still delivers a full position, the driver usually notices only the warning; GM's patent lets the module carry on with the remaining valid signal. Sensor A low is P2E02, sensor B high P2E07. CARB 1968.2 (e)(15) requires such out-of-range checks.
Possible causes
- Signal line of sensor B shorted to ground high
- Supply branch of sensor B dead medium
- Sensor B output stuck low medium
Symptoms
- Warning lamp after two trips
- Selector keeps working on sensor A
- Range selection lost if sensor A fails as well
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2E06
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.