OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E04

Gear Lever Position Sensor B Circuit

Sensor B is the second, redundant gear lever position sensor; it measures the same lever travel as sensor A so that a single failure does not leave the driver without range selection. Toyota names it gear lever position sensor B in the floor shift assembly of the Lexus NX, and GM's tables call the equivalent device sensor 2, with X and Y values of its own (P089B to P08A2). P2E04 is the general circuit fault of sensor B, set when its line is open or its signal cannot be read, with no low/high distinction. No maker documents P2E04 itself. GM's patent US9249877 describes the logic behind the pair: if a coordinate of one sensor fails its test, that sensor is ignored and the other decides. A fault here therefore removes the backup, not the function.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 04

Possible causes

  • Connector or wire of sensor B at the selector loose or damaged high
  • Sensor B in the selector assembly failed medium
  • Separate supply branch of sensor B interrupted low

Symptoms

  • Warning lamp or shift-system message
  • Selector works normally on sensor A alone
  • Any further sensor fault can block range changes

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2E04

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication