OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2E03

Gear Lever Position Sensor A Circuit High

With P2E03 the module sees the signal of sensor A above the highest value the sensor can legitimately send. On a pulled-up input this happens when the signal wire is open; it also follows a short to the supply or a lost sensor ground. No manufacturer publishes P2E03. GM checks the same kind of fault axis by axis on the XT4 selector: P082C and P082F set when the duty cycle of X or Y sensor 1 rises above 95 % (19OBDG03D, 3 of 4 samples, Type B, MIL after two trips). GM's patent explains the consequence: a coordinate that fails makes that sensor's whole position signal invalid, and the module relies on the second sensor. P2E02 is the low side, P2E07 the same high fault on sensor B. CARB 1968.2 (e)(15) requires this two-sided check.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberE / 03

Possible causes

  • Signal wire of sensor A open at a connector high
  • Signal wire shorted to supply voltage medium
  • Ground of sensor A interrupted medium

Symptoms

  • Warning lamp after two trips
  • Shift-system message, ranges still selectable via sensor B
  • Start or range change refused if both sensors are affected

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2E03

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication