P2E02
Gear Lever Position Sensor A Circuit Low
P2E02 says the signal of gear lever position sensor A is stuck below the lowest value a healthy sensor can output. Typical reasons: the signal wire touches ground, the reference voltage is missing, or the sensor output has collapsed. No manufacturer publishes P2E02. The closest documented check is GM's per-axis version on the Cadillac XT4 electronic selector (19OBDG03D): X sensor 1 sets P082B, Y sensor 1 P082E, when the PWM duty cycle falls under 5 % in 3 of 4 samples at 25 ms, Type B. CARB 1968.2 (e)(15) asks for out-of-range detection on transmission inputs and keeps circuit and rationality faults under separate codes. The high counterpart is P2E03, sensor B low is P2E06. With a valid partner sensor the lever normally keeps working.
Possible causes
- Signal wire of sensor A shorted to ground high
- Sensor reference voltage missing or pulled down medium
- Sensor A output failed low medium
Symptoms
- Warning lamp and shift-system message
- Lever position shown on the display jumps or is missing
- If sensor B also fails, no range can be selected
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2E02
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.