P2E00
Gear Lever Position Sensor A Circuit
Gear lever position sensor A is the first of up to four sensors through which an electronic selector tells its control module where the lever sits. In the designs GM and Toyota document, A and B form a redundant pair that each report the full lever position; GM's patent US9249877 has each of its two sensors deliver an x and a y value. P2E00 is the umbrella circuit fault of sensor A: an open line, a lost supply or a signal the module cannot evaluate, without splitting it into low or high. No manufacturer documents P2E00 publicly; in its 2025 ECM tables GM lists only P2E01 for this sensor and suspends that test while lost-communication U codes are stored. CARB 1968.2 (e)(15) requires circuit monitoring of such transmission inputs. With sensor B valid, shifting usually continues.
Possible causes
- Loose connector or chafed wire at the selector assembly high
- Supply or ground of sensor A interrupted medium
- Sensor A inside the selector assembly failed medium
- Input stage of the evaluating module faulty low
Symptoms
- Warning lamp or shift-system message
- Gear selection still possible through sensor B, sometimes delayed
- With a second fault, the vehicle may stay in P or N
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2E00
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.