OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2DFB

Coolant Pump E Control Module Overtemperature

Electric coolant pumps carry their own driver electronics, and P2DFB reports that those of coolant pump E have run too hot. Which loop pump E serves differs between makers. No manufacturer documents P2DFB publicly, but its siblings show the pattern: Ford's 2024 gasoline summary lists over temperature as fault type 98 of its auxiliary pumps A and B, watched continuously from 11 V with a 5 second monitoring time, and Ford's 2019 hybrid summary lets the engine coolant pump send its module temperature over LIN, setting P26D2 above 130 °C for 5 seconds. Because the liquid it moves also cools the electronics, low level, trapped air, a stiff impeller or heat from nearby exhaust parts are the usual triggers. The pump then slows or stops, and the served loop may overheat.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / FB

Possible causes

  • Coolant level too low or air trapped in the pump, so the electronics lose their cooling high
  • Impeller or bearing running stiff, motor draws high current and heats up medium
  • Driver electronics inside pump E faulty or reporting temperature wrongly medium
  • Heat shield missing or pump too close to hot exhaust or turbo parts low

Symptoms

  • Warning lamp or message about the cooling system
  • Reduced cabin heating or cooling of the component served by pump E
  • Pump runs at reduced speed or stops for a while, often together with air or stall codes

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2DFB

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication