OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2DF5

Coolant Pump E Control Circuit Low

P2DF5 means the command line of coolant pump E sits too low, typically shorted to ground, so the module's driver cannot pull it up to the commanded level. No manufacturer documents this code publicly. In Ford's 2024 gasoline OBD summary the matching fault type is 11 (circuit low), again flagged by the smart driver for pumps A and B, continuously above 11 V. Because a PWM pump reads duty cycle, a line held at ground can mean zero duty; depending on the pump design this is read as stop, as maximum speed or as a fault state. CARB requires output components to be checked for shorts as well as for proper response. Look for chafed insulation against body or engine parts and water in the connector. The open circuit is P2DF4, a short to voltage P2DF6, the pump power feed P2DFA.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / F5

Possible causes

  • Command wire chafed through and shorted to ground high
  • Moisture or corrosion bridging the command pin to ground medium
  • Internal short in the pump's control input medium
  • Output stage of the commanding module defective low

Symptoms

  • Warning lamp on
  • Pump stopped or stuck at one speed
  • Rising temperature of the component served by pump E

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2DF5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication