OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2DF4

Coolant Pump E Control Circuit/Open

Electric coolant pumps are usually commanded through a PWM wire or a LIN bus, and pump E is the fifth such pump in a vehicle's lettering; what it cools depends on the manufacturer. P2DF4 reports an open or otherwise faulty command line to pump E. No manufacturer documents P2DF4 publicly. Ford shows the pattern for its pumps A and B in the 2024 gasoline OBD summary: the base code is fault type 13 (circuit open), set when the module's smart driver reports an output fault, monitored continuously above 11 V over 5 seconds. Bosch's PDE pump, a typical example, carries its own motor and diagnostic electronics and takes speed commands via PWM or LIN. With an open line many pumps default to a fixed speed or stop, so the cooled component may overheat. Shorts are P2DF5 and P2DF6.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / F4

Possible causes

  • Pump connector loose, corroded or with pushed-back pin high
  • Broken command wire in the harness medium
  • Pump electronics with failed control input medium
  • Faulty output driver in the commanding module low

Symptoms

  • Warning lamp on
  • Pump runs at fixed speed or not at all
  • Temperature warning or power reduction of the cooled component

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2DF4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication