P2DF1
Intake Valve Lift Range/Performance Bank 2
P2DF1 is the bank 2 counterpart of P2DF0 and therefore only appears on V engines or boxers, on the side without cylinder 1. Nissan's VVEL, used on the VQ37VHR V6 and on V8 engines, is a good example: on the 2014 QX80 V8 both banks carry a separate VVEL ladder assembly with an actuator and a control shaft position sensor. Infiniti's bulletin ITB14-041 for the 2014 QX80 warns never to loosen the ladder adjusting bolts or the sensor mounting bolts, because the cam lift stroke then goes out of adjustment and ladder plus cylinder head must be replaced. A wrong reading from that sensor or a binding shaft therefore shows up as a lift error on one bank only. No manufacturer documents P2DF1 publicly; under CARB's VVT section the lift system must be watched for both kinds of deviation.
Possible causes
- Control shaft or ladder assembly on bank 2 binding high
- Control shaft position sensor on bank 2 moved or faulty medium
- Lift actuator motor of bank 2 weak medium
- Oil sludge in the bank 2 lift mechanism low
Symptoms
- Check engine light on
- Uneven running between the banks, possible fuel trim difference
- Reduced power
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2DF1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.