P2DEB
Cylinder 2 Intake Valve Lift Range/Performance
P2DEB singles out cylinder 2: its intake valve lift misses the target or follows a command too late. Lift control for each cylinder separately is the hallmark of electro-hydraulic systems like Fiat's MultiAir, sold by Schaeffler as UniAir: per cylinder, a solenoid decides how much of the cam stroke is passed through an oil-filled chamber to the intake valves; once it opens, the link collapses and a spring takes over. FCA reports faults on its 2.4 L MultiAir with its own per-cylinder P1xxx codes (P1037, P103A, P103D, P1040 for a valve shorted to ground) and has technicians measure the PCM driver pins, which should read about 15 kOhm and never below 10 kOhm, before buying a new actuator. Nobody documents P2DEB itself publicly. Symptoms: cylinder 2 misfire, rough idle.
Possible causes
- Cylinder 2 solenoid in the lift actuator responding slowly or leaking internally high
- Aged, contaminated or wrong-grade engine oil in the hydraulic chamber high
- Air in the high-pressure chamber after oil starvation or service medium
- Damaged driver stage in the engine control module low
Symptoms
- Check engine light on
- Misfire felt at idle, cylinder 2 misfire count rising
- Reduced power at higher load
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2DEB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.