OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2DE9

Cold Start Engine Coolant Pump Underspeed

Engines with an electric main water pump run it at a tightly metered speed after a cold start so the block heats quickly. P2DE9 flags that during this phase the pump turns too slowly. GM's 2025 ECM tables (25OBDG03B) filter the gap between requested and reported pump speed and fail the check when it exceeds 200 rpm for 8 of 10 seconds, with low-flow coolant mode and catalyst warm-up active, the request steady within 50 rpm for at least 3 s, and inlet coolant at −40 °C or warmer; two calibrated limits exist because the reachable speed depends on system voltage. Type B, MIL after two trips. Outside the warm-up phase the same fault is P2B85; pump faster than requested during cold start is P2E82. CARB demands such separate cold-start codes and a monitoring plan for electric water pumps.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / E9

Possible causes

  • Worn pump bearing or debris at the impeller slowing the rotor high
  • Low supply voltage at the pump (battery, ground, connector) medium
  • Faulty pump electronics or speed feedback medium
  • Wrong or aged coolant, very thick when cold low

Symptoms

  • Check engine light on after two trips
  • Uneven warm-up, local hot spots possible
  • Often no noticeable symptom

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2DE9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication