OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2DE7

Cold Start Engine Coolant Bypass Valve C Range/Performance

California requires a fault found while the cold-start warm-up strategy runs to be stored apart from the same fault found later. P2DE7 is that cold-start counterpart of P26BB for coolant valve C. GM's 2025 ECM tables (25OBDG03B) set it when the valve's measured angle is more than 12° off its target after the target has settled, or when the valve moves slower than calibrated, during 4 of 5 seconds. Extra conditions are a low-flow coolant mode (also during auto-stop), active catalyst warm-up, closed-loop position control without soft opening, soft closing or anti-stick routine, and outlet coolant above −20 °C. Type B, MIL after two trips. A slow valve can let coolant circulate too early, so engine and catalyst heat up later. Position-sensor faults (P23C3 ff.) block the test.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / E7

Possible causes

  • Rotary valve sluggish from deposits or worn seals high
  • Valve actuator motor or gearing weak medium
  • Position sensor reading drifting without a circuit fault medium
  • Engine control software needing an update low

Symptoms

  • Check engine light on (after two trips)
  • Engine and cabin heater warm up more slowly
  • Usually no change in driveability

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2DE7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication