OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2DE0

Cold Start Fuel Injection Quantity C Lower Than Expected

P2DE0 is the cold-start shortfall for path C. Its partner P2DE1 is used by Honda, which treats it as a rich fault of its cold-start mixture control: that check compares the ratio the PCM commands just after a cold start with what the wide-band sensor measures. By the logic of the pair, P2DE0 would be the lean side, but no public Honda or other maker document covers P2DE0 itself. For petrol engines, CARB section 1968.2 (e)(11.1.3) requires cold-start faults to be stored apart from the same faults found later. Fuel shortfall when cold can stem from low fuel pressure, an air leak behind the airflow meter or injectors that atomise poorly; stalling or stumbling soon after starting is typical. P2DDC is the warm counterpart.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / E0

Possible causes

  • Fuel pressure too low at start (pump, regulator, check valve) medium
  • Unmetered air entering behind the airflow meter medium
  • Injectors of group C dirty, poor spray when cold medium
  • Cold-start calibration in engine control software low

Symptoms

  • Check engine light on after a cold start
  • Stalling or stumbling shortly after a cold start
  • Long cranking when cold

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2DE0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication