P2DD9
EVAP System Leak Detection Pump Control Circuit Performance
P2DD9 means the drive circuit of the evaporative leak detection pump is electrically intact, yet the pump does not react the way the command implies: the feedback the engine computer reads back, usually motor current or driver state, does not match the on or off request. Bosch-style DM-TL pumps on European cars are judged by their motor current, first while blowing through a 0.5 mm (0.020 in) reference orifice and then against the closed tank, so a sluggish motor or a resistive plug skews the entire leak test. CARB wants EVAP parts checked for proper functional response as well as for opens and shorts. GM's 2025 tables suspend their pump tests while a pump circuit fault is active. No maker documents P2DD9 publicly; plain circuit faults are P2400 to P2402. Driving is unaffected, only the leak check is lost.
Possible causes
- Pump motor worn or sluggish, current draw off target high
- Corroded connector or chafed wire adding resistance in the pump feed medium
- Water or ice in the pump module (mounted near the wheel arch) medium
- Faulty output stage or current sensing in the engine control module low
Symptoms
- Check engine light on
- EVAP readiness monitor stays incomplete
- No noticeable change in driving
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2DD9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.