P2DD4
Control Pilot Charging Switch B Stuck On
P2DD4 describes the reverse case: switch B remains closed against the module's command to open, and the pilot goes on asking for energy at about 6 V although charging should have ended or paused. Welded or sticking contacts, a driver stage shorted on, or software that does not release the switch are all possible. For switch A, Mercedes-Benz traced the corresponding code P0CFE to the AC charger software and cured it by SCN coding, advising against swapping parts, so an update check comes first. No manufacturer documents P2DD4 publicly. CARB requires plug-in hybrids to monitor the on-board charger. Counterpart: P2DD3; circuit faults: P2DCE to P2DD1. Scheduled charging pauses may be ignored, or the session may end with an error message instead of finishing normally.
Possible causes
- Charger software not releasing the switch medium
- Welded or sticking switch contacts medium
- Driver stage permanently switched on low
Symptoms
- Charging does not end or pause as planned
- Charging error message after the session
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2DD4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.