P2DD3
Control Pilot Charging Switch B Stuck Off
Stuck Off: although the module orders charging switch B to close, nothing changes on the pilot; the voltage sits near 9 V, the plugged-in level, rather than dropping to about 6 V. Through this switch the station thus never sees a request for energy. A contact or relay that will not close, a broken 1.3 kΩ resistor or an error in the pilot measurement can each cause this. CARB generally treats a missing functional response to a command as an output component fault, and its plug-in section adds charger faults that stop charging. No manufacturer documents P2DD3 publicly. The opposite case is P2DD4; circuit faults are P2DCE to P2DD1; the switch A equivalent is P0CFD. At the station the car is recognised and may show as plugged in, yet no energy flows.
Possible causes
- Switch or relay B no longer closing high
- Open resistor in the charge-request branch medium
- Pilot voltage measurement in the module faulty low
Symptoms
- Car recognised at the station but no charging
- Charging error message
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2DD3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.