P2DD2
Control Pilot Charging Switch B Intermittent/Erratic
P2DD2 is stored when the signal of charging switch B changes state erratically: it drops out or toggles for brief moments, while lasting faults would end up as P2DCE, P2DD0 or P2DD1. Loose terminals, green corrosion at inlet pins or the module plug, and conductors that break contact only when the car moves or temperatures change are the usual suspects. On the pilot line each lost request counts: a J1772 station supplies power only while it sees roughly 6 V, the level that asks for current, so every dropout makes it switch off and possibly on again. No manufacturer documents P2DD2 publicly; under CARB rules a plug-in hybrid must notice a charger fault that breaks off charging. Switch A counterpart: P0CFC. Charging sessions stop and restart for no visible reason, and the battery may not be full in the morning.
Possible causes
- Loose terminal in the charge inlet or module connector high
- Corrosion from water ingress at the charge inlet medium
- Chafed wire losing contact with movement or temperature low
Symptoms
- Charging stops and restarts repeatedly
- Battery not fully charged after a charging session
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2DD2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.