OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2DD1

Control Pilot Charging Switch B Circuit High

P2DD1 reports a voltage on the drive or feedback wire of switch B that is higher than it should be. Likely culprits are a wire touching battery voltage or another feed somewhere between inlet and module, or a transistor stage that has lost the ability to pull its output low. Whether the switch then stays open or closed depends on the design. If it stays open, the pilot remains at about 9 V, the J1772 state of a connected vehicle that does not ask for energy, and the station keeps the cable dead. No manufacturer documents P2DD1 publicly; CARB's plug-in rules ask for detection of on-board charger faults that prevent charging. Low side: P2DD0; plausibility: P2DCF; switch A high: P0CFB. Check connectors for moisture and pushed-back pins before replacing the module.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / D1

Possible causes

  • Switch B line shorted to a supply voltage high
  • Driver stage in the charging module no longer pulling low medium
  • Moisture or pushed-back pins at inlet or module connector medium

Symptoms

  • Car stays in plugged-in state, station supplies no power
  • Charging session cannot be ended cleanly

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2DD1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication