P2DD0
Control Pilot Charging Switch B Circuit Low
P2DD0 says the drive or sense wire of switch B reads below its valid range. The usual reasons are a wire chafed through to body ground or a shorted transistor stage in the charging electronics. Depending on how the switch is driven, a grounded line can hold it permanently closed, so the pilot stays at the charge-request level of about 6 V, or keep it from ever closing. CARB requires plug-in hybrids to recognise charger faults that block or limit charging, but exempts failures that cannot be told apart from problems at the station; a short inside the vehicle is clearly on the car side. No manufacturer documents P2DD0 publicly. Owners may see charging begin as soon as the cable is connected, or not at all. High: P2DD1; open: P2DCE; switch A low: P0CFA.
Possible causes
- Switch B wire chafed and shorted to ground high
- Output stage in the charging module failed shorted medium
- Moisture in the charge inlet creating a leakage path low
Symptoms
- Charging starts immediately on plug-in or not at all
- Timed charging not followed
- Charging fault message
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2DD0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.