P2DCE
Control Pilot Charging Switch B Circuit/Open
P2DCE reports an open or otherwise faulty control circuit of charging switch B, a vehicle-side switch on the control pilot line. Under SAE J1772 the car first loads the pilot with about 2.74 kΩ, pulling the 12 V supplied by the station down to roughly 9 V; closing a charging switch puts another 1.3 kΩ in parallel, the level falls to about 6 V and the station energises the cable. With the circuit of switch B interrupted, the module cannot place this request through it. Which hardware the letter B stands for, such as a second charge inlet or a redundant path, is not published, and no manufacturer documents P2DCE. CARB asks plug-in hybrids to detect charger faults that stop or limit charging. Switch A counterpart: P0CF8. Expect a car that the station recognises but that does not charge.
Possible causes
- Broken wire or pushed-back pin in the switch B circuit high
- Switch or its driver inside the charging module open medium
- Corroded contacts at the charge inlet or module connector medium
Symptoms
- Station detects the car but charging never starts
- Charging fault message in the instrument cluster
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2DCE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.