OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2DCC

Starter/Generator Position Sensor Correlation

P2DCC reports that the rotor position or speed the starter/generator derives from its own sensor disagrees with an independent reference. For a belt-driven machine the natural reference is the crankshaft: engine speed times the pulley ratio has to match machine speed. GM's eAssist runs this comparison under the drive motor performance code P0A90: more than 1,000 rpm between machine and ECM speed for 1.5 s within 2 s sets it as a one-trip Type A, while gaps above 500 rpm are counted over two key cycles. GM also watches the resolver for a tracking error above 5 degrees. A slipping belt can therefore look like a sensor fault. No manufacturer documents P2DCC publicly. Lacking a reliable angle, the controller usually stops assist and auto-start; CARB asks that such generator faults be detected.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / CC

Possible causes

  • Slipping drive belt or weak belt tensioner high
  • Rotor position sensor degraded or shifted medium
  • Faulty engine speed reference from the crankshaft sensor or its CAN signal low

Symptoms

  • Start-stop and electric assist disabled
  • Belt squeal or engine restart via 12 V starter instead
  • Check engine light

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2DCC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication