P2DCA
Starter/Generator Excitation Current Intermittent
P2DCA is set when the field current of a starter/generator with electrically excited rotor does not stay steady but drops out or jumps for short moments, without staying beyond the low or high limit long enough for P2DC8 or P2DC9. The rotor coil of a claw-pole machine such as Valeo's 48 V iBSG receives its current through brushes running on slip rings, so worn or sticking brushes and dirty or worn rings are typical sources of such dropouts; a loose plug on the field leads or a cracked solder joint in the excitation bridge can do the same. Each dropout briefly collapses the rotor field, making torque and charging current fluctuate. No manufacturer documents P2DCA publicly. Drivers may notice uneven engine restarts or a flickering charge warning. General fault: P2DC7.
Possible causes
- Worn or sticking brushes, dirty or worn slip rings high
- Loose connector or terminal on the field leads medium
- Cracked solder joint in the excitation bridge of the controller low
Symptoms
- Charge warning that comes and goes
- Jerky or delayed restarts after start-stop
- Electric boost and recuperation work only at times
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2DCA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.