OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2DC7

Starter/Generator Excitation Current

P2DC7 is the general fault for the excitation current of a starter/generator, meaning the DC current in the rotor field winding does not behave as commanded. Only wound-field machines have one. Valeo's 48 V belt starter generator, for instance, is a synchronous claw-pole machine; in such designs the stator gets three-phase current from an inverter, while a separate H-bridge drives direct current through brushes and slip rings into the rotor coil. Permanent-magnet starter/generators need no excitation, so the code does not apply to them. Regulator chips for wound-field alternators measure this current and can limit it, which is the basis for such checks. Switching the field off is also a safety tool against DC-link overvoltage. No manufacturer documents P2DC7 publicly. Low: P2DC8; high: P2DC9.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / C7

Possible causes

  • Worn brushes or contaminated slip rings on the rotor high
  • Fault in the excitation H-bridge of the starter/generator electronics medium
  • Rotor field winding with interrupted turns or a short medium

Symptoms

  • Battery or charging warning lamp
  • Starter/generator stops charging and assisting
  • Stop-start disabled

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2DC7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication