OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2DC6

Starter/Generator Phase Z Current Sensor Circuit Range/Performance

P2DC6 is the plausibility code for the starter/generator's phase Z current sensor. The reading stays within its electrical window but does not match what the controller expects from commanded current and machine state. Care is needed to separate this from a real winding problem: GM's eAssist logic, for example, watches the peak current of each phase as the rotor turns and stores a separate open-phase code when it stays under 9 A although at least 25 A are commanded. A low Z value can thus mean a weak sensor or a phase that truly carries little current. CARB demands rationality faults in their own code, apart from circuit faults. No manufacturer documents P2DC6 publicly. Circuit: P2DC5; Z high and low: P2D94, P2D97; phase correlation: P2DCB.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / C6

Possible causes

  • Phase Z sensor has lost sensitivity or drifted high
  • Real current deviation from a poor phase Z connection or winding fault medium
  • Controller software or calibration judging the signal wrongly low

Symptoms

  • Warning lamp, usually after two trips
  • Reduced starter/generator output or rough automatic restarts

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2DC6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication