P2DC3
Starter/Generator Phase Y Current Sensor Circuit
P2DC3 flags an electrical fault in the circuit of the phase Y current sensor of the starter/generator. Such a sensor needs a supply, a ground and a signal line, and a break or short in any of the three can end up here when the controller cannot or does not tell high from low. Under CARB's rule the hybrid parts a manufacturer chooses to monitor are checked like any other input component, and the manufacturer has to get its hybrid monitoring plan approved. Not every machine has a Y sensor: GM's eAssist table covers only phases U and W, so a vehicle storing P2DC3 uses a different layout. No manufacturer documents P2DC3 publicly. Measure supply and ground at the sensor plug before condemning the machine. Range check: P2DC4; high and low: P2D93, P2D96.
Possible causes
- Missing supply or ground at the phase Y sensor high
- Open phase Y signal line between sensor and controller medium
- Phase Y current sensor without output medium
Symptoms
- MIL or hybrid warning
- Automatic stop-start disabled
- Battery charged less by the starter/generator
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2DC3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.