P2DC2
Starter/Generator Phase X Current Sensor Circuit Range/Performance
P2DC2 means the starter/generator's phase X current sensor delivers values that are electrically valid but do not make sense. CARB requires such rationality faults to be detected where feasible and kept in a code of their own, separate from wiring and out-of-limit faults. One published method is the zero check: when the inverter is not switching, no phase current flows, so the reading should be near zero. GM's eAssist machine filters this offset over eight loops and treats more than 30 A as a fault on its U and W sensors, which GM files under the Range/Performance codes of drive motor A. No manufacturer documents P2DC2 publicly. A drifting sensor zero, a corrupted reference voltage or a sensor slowly failing are likely. Circuit fault: P2DC1; high and low: P2D92, P2D95.
Possible causes
- Zero point of the phase X sensor drifted, for example through ageing or heat high
- Sensor reference voltage out of tolerance medium
- Phase X current sensor with gain error or slowly failing medium
Symptoms
- Warning lamp after the plausibility check has failed on two trips
- Less electric torque because current control runs in a substitute mode
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2DC2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.